Preparing Hot Milk With The Professional Cappuccino Frother; Rinsing The Professional Cappuccino Frother - Jura IMPRESSA XF50 Instructions For Use Manual

Type 661
Table of Contents

Advertisement

Open the steam / hot water draw-off tap (Fig. 13) to draw off steam.
The milk foam is prepared.
The illuminated ring (2) is active.
STEAM
You can adjust the steam preparation time individually by turning
the Rotary Switch (1) until the desired number of SEC appear on the
display.
For example
25 SEC.
If you do not change the steam preparation time on the Rotary
Switch (1), you prepare the saved amount of steam.
Adjust the steam preparation time to suit the size of your cup.
Once the amount of steam is reached, the following message
appears on the display:
CLOSE TAP
Close the steam / hot water draw-off tap (14).
READY
The machine is ready to prepare steam for around 40 sec., then
the machine is reset so that it is ready to brew coffee.
You can prematurely stop steam preparation at any time by
closing the steam / hot water draw-off tap (14).
Due to the system design, some steam and milk may be re-
leased before the tap is closed. There is a danger of scalding.
Now, move your cup with the milk foam under the coffee spout
and draw off the desired speciality coffee (Fig. 8). Your cappuccino
is ready.
13.2 Preparing hot milk with the Professional
Cappuccino Frother
Turn the selector switch on the Professional Cappuccino Frother
to the Milk position (Fig. 20).
The operation for preparing hot milk is the same as that for
preparing milk foam for a cappuccino (see chapter 13 'Preparing
cappuccino with the Professional Cappuccino Frother').

13.3 Rinsing the Professional Cappuccino Frother

To ensure that the Professional Cappuccino Frother (15) works
perfectly, you should rinse it with water after every milk prepa-
ration.
Your IMPRESSA will not prompt you to rinse the Professional
Cappuccino Frother.
READY
Remove the milk pipe from the milk carton or the milk container.
Fill a receptacle with fresh water and immerse the milk pipe in it.
Place a receptacle under the Professional Cappuccino Frother and
move the selector switch to the Milk foam or Milk position.
Press the steam preselection button
HEATING
READY
(8).
15
E

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Impressa f50 classic

Table of Contents