Heating Milk With The Professional Cappuccino Frother - Jura ENA3 User Instruction Manual

ENA 3
E
If the nozzle does not reach into the cup, lift
the cup towards the nozzle.
g T
Turn the Rotary Switch until
displayed.
k T
Press the Rotary Switch.
HEATING
appears as soon as the ENA is
READY
sufficiently heated.
l T
Turn the switch to position
, the milk is foamed by the hot
STEAM
steam.
y T
Turn the switch to position
milk foam has reached the required
consistency.
E
You can prepare more steam within about
40 seconds.
T
Place the cup under the coffee spout.
k T
Press the Rotary Switch to start coffee
preparation.
, the pre-set amount of water
1 CUP
flows into the cup. Preparation stops
automatically.
To ensure that the 2-stage frothing
nozzle works perfectly, it should be
rinsed regularly (refer to Chapter 4
'Maintenance – Dismantling and rinsing
the 2-stage frothing nozzle').
Heating milk with the
Professional Cappuccino Frother
Precondition:
READY
T
Remove the protective cover from the
Professional Cappuccino Frother.
T
Connect the milk pipe to the nozzle.
T
Insert the other end of the milk pipe into a
milk carton or connect it to a milk
container.
T
Place a cup under the nozzle.
20
is
STEAM
m
.
o
when the
appears on the display.
T
Set the selector lever of the nozzle to the
t
milk position.
g T
Turn the Rotary Switch until
displayed.
k T
Press the Rotary Switch.
HEATING
appears as soon as the ENA is
READY
sufficiently heated.
l T
Turn the switch to position
, the hot milk is being prepared.
STEAM
y T
Turn the switch clockwise to position
when there is sufficient milk in the cup.
E
You can prepare more hot milk within
about 40 seconds.
To ensure that the Professional Cappuccino
Frother works perfectly, it should be rinsed
and cleaned regularly (refer to Chapter 4
'Maintenance – Professional Cappuccino
Frother').
is
STEAM
m
.
o