Using For The First Time; Adjusting The Water Hardness - Jura IMPRESSA XF50 Instructions For Use Manual

3. Using for the first time

Fill the bean container with coffee beans (12).
Switch your IMPRESSA on with the On/Off button
SPRACHE
DEUTSCH
The illuminated ring (2) is active.
Turn the Rotary Switch (1) until the desired language appears on
the display.
Now confirm your selection by pressing the Rotary Switch (1).
FILL
WATER TANK
Remove the water tank (10) and fill with fresh water. Refit the water
tank in your IMPRESSA.
OPEN TAP
Place receptacle under the Professional Cappuccino Frother (15)
(Fig. 10).
Now open the steam / hot water draw-off tap (14) (Fig. 13).
SYSTEM
FILLING
CLOSE TAP
Close the steam / hot water draw-off tap (14).
SYSTEM
FILLING
HEATING
PRESS
RINSE
Press the Maintenance button
8
(21).
(3).
The machine rinses.
RINSING
READY
If FILL BEANS appears on the display, again press any coffee
preparation button. The grinder is not yet filled with coffee
beans.
To get a really good crema you can individually adjust the
height-adjustable coffee spout (17) to your cup sizes (Fig. 3).

4. Adjusting the water hardness

Water is heated in the IMPRESSA. Over time this will result in
calcification and this is displayed automatically. The IMPRESSA
must be set to the hardness of the water used. Use the test
strips provided.
1° German hardness corresponds to 1.79° French hardness.
When the filter is activated, the water hardness programme
item disappears.
The IMPRESSA is set to 16° dH by default. You can change this setting.
Proceed as follows:
READY
Press and hold the Rotary Switch (1) until RINSE appears on the dis-
play.
The illuminated ring (2) is active.
Turn the Rotary Switch (1) until the following message appears on
the display: