Flowcharts - Datalogic Magellan 2200VS Reference Manual

Problem Isolation

Flowcharts

Power-up
Scanner power-up is signified by
any or all of the following:
- Facet wheel shows movement
- Laser turns on
- Status LED lights
- Speaker sounds tone(s)
Flashing Green LED
If the Green LED is flashing slowly, the
scanner is most likely in Sleep Mode.
Press and release the Volume/Tone
Push Button or wave your hand in front
of the vertical window to "wake-up" the
scanner.
A flashing Green LED can also mean
the scanner has been disabled by the
POS terminal. To exit this mode, cycle
power or have the terminal re-enable
the scanner.
Selftest Failure
If the scanner fails its Selftest, the
following takes place:
- Speaker sounds a tone at the lowest
value for approx. 3 seconds.
- LED flashes on and off.
Consult the Selftest flowchart if you're
unsure the unit has passed Selftest.
Other Problems?
Call Tech Support
34
The problem isolation flowcharts on the following pages allow you to
identify and troubleshoot problems with your system.
Figure 4-1. Problem Isolation: Start
START
Does
the scanner
power-up
YES
Is the
Green LED
Lit
YES
Does
the scanner
pass Selftest
YES
Will the
YES
scanner read
bar codes
reliably
For units using an AC/DC adapter, verify that...
1. AC Adapter is connected to a functional AC outlet.
2. Power cord is firmly connected to scanner.
If your unit is a model which receives Power Off the
Terminal POT), verify that the I/F cable is securely
connected at both ends.
NO
Have you
NO
checked the
power
connections
?
?
Ensure the Green LED is
NO
enabled via pro-
gramming bar codes.
?
NO
Go to Selftest
flowchart
?
NO
Go to Poor/No
Reading flowchart
?
®
Magellan 2200VS/2200VS and 2300HS/2300HS
Scanner
AC
Adapter
Check these
YES
potential problems:
- AC/DC adaptor
- AC outlet
Is the
Green LED
Lit
?
YES
Call Tech Support
NO