Installing The Switch On A Table Or Desktop - Allied Telesis AT-FS7016 Installation Manual

Installing the Switch on a Table or Desktop

If you are rackmounting an AT-FS7016 or AT-FS7024 switch, refer to
"Rackmounting the Switch" on page 17.
To install the switch on a table or desktop, perform the following procedure:
1. Remove all equipment from the packaging and store the packing material
in a safe place. In the event a problem occurs and you need to return the
unit, please use as much of the original shipping material as possible.
2. For the AT-FS7016 switch, attach the four protective feet to the bottom of
the unit. See Figure 7.
Figure 7 Attaching the Rubber Feet (AT-FS7016 only)
Note
The protective rubber feet for the AT-FS7024 switch are pre-installed.
3. Place the switch on a flat, secure surface leaving ample space around the
switch for ventilation.
4. Apply power to the switch by plugging the AC power cord into an AC power
outlet; then plug the other end of the power cord into the receptacle located
on the back of the switch.
5. Verify that the POWER LED is green. If the LED is OFF, refer to
"Troubleshooting" on page 21.
Note
The switch performs a self-diagnostic test upon power up. This takes
about 20 seconds to complete.
6. Connect the twisted pair cables to a twisted pair ports on the switch and on
the end-nodes. When connecting a twisted pair cable to a port on the switch,
observe the following:
❑
An RJ-45 connector should fit snugly into the port on the switch. The
tab on the connector should lock in connector into place.
AT-FS7016 and AT-FS7024 Installation Guide
15