Rackmounting The Switch - Allied Telesis AT-FS7016 Installation Manual

Rackmounting the Switch

The AT-FS7016 and AT-FS7024 switches can be used on a desktop or installed
in a rack. For desktop installation, refer to "Installing the Switch on a Table or
Desktop" on page 15.
To install the switch in a rack, perform the following procedure:
1. If attached, remove the four protective rubber feet from the bottom on the
unit.
❑
For the AT-FS7016 switch, remove the protective feet from the bottom
of the unit, as shown in Figure 8.
❑
For the AT-FS7024 switch, remove the protective feet from the bottom
of the unit, as shown in Figure 9.
Figure 8 Removing the Protective Feet (AT-FS7016)
Figure 9 Removing the Protective Feet (AT-FS7024)
AT-FS7016 and AT-FS7024 Installation Guide
17