Allied Telesis AT-FS7016 Installation Manual page 28

Installation
2. Attach the rackmounting brackets to each side of the switch using the
screws provided. See Figure 10.
Figure 10 Attaching the Rackmounting Brackets to the Switch
3. Secure the switch to the rack using two screws (not provided) for each side,
as shown in Figure 11.
4. Apply power to the switch by plugging the AC power cord into an AC power
outlet; then plug the other end of the power cord into the receptacle located
on the back of the switch.
5. Verify that the POWER LED is green. If the LED is OFF, refer to
"Troubleshooting" on page 21.
18
Figure 11 Installing the Switch to the Rack