The Ethernet Board; Description Of The Ethernet Board; Network Settings - Barco iD H250 Service Manual

5.4.3.6

The ethernet board

5.4.3.6.1

Description of the ethernet board

What does the ethernet board do?
Image 5-24
Input module: ethernet board
The ethernet communication can be used to:
• download new software on the projector (upgrading)
• set up serial communication with the projector (TCP packets)
This RJ45 connector is connected to the ethernet switch on the PMP.
5.4.3.6.2

Network settings

What can be done?
These settings are used to set the Ethernet Communication parameters.
The Ethernet connection can be used to upload/download projector software and/or to set up RS232 communication (TCP-packets)
with the projector.
Following parameters are available :
MAC Address
IP Address (Current)
Subnet Mask
Gateway
DHCP
IP Address
Subnet Mask
Gateway
Hostname
How to set up the network settings ?
1. Press the MENU key to activate the Menu bar.
R59770097 ID H250 / H500 15/05/2007
MAC Address of the projector (This is a non-adjustable value programmed into the Ethernet
board).
IP Address of the projector (This is a non-adjustable value ).
Subnet Mask (This is a non-adjustable value )
Gateway (This is a non-adjustable value )
DHCP setting:
• Yes: The projector will dynamically obtain its IP address from the DHCP server.
• No: The IP address needs to be entered manually. Note that when selecting Fxed IP
the IP settings fields are enabled
Fixed IP Address of the projector : this field can be edited when Fixed IP is selected
Subnet Mask : this field can be edited when Fixed IP is selected
Gateway : this field can be edited when Fixed IP is selected
Hostname : this field can be edited when DHCP is selected
5. Electronic spares and servicing procedures
41