5. Electronic spares and servicing procedures
Image 5-53
Fan connector board
7. Remove the cable strap of the lamp power cable at the rear side of the power box
Image 5-54
Remove the cable strap of the lamp power cable
8. Shift the power box a bit forward and upward and unplug the following connectors on the right side of the power box:
-
5: power supply for the lightpipe fan
-
6: power supplies for the boards (++12V, +12V, +12VA)
-
7: lamp temperature sensors
-
9: ambient temperature sensor
-
13: communication with PMP
-
17 & 18: LPS control
-
19 & 20: lens motor control
-
21: power supply for LPS
56
R59770097 ID H250 / H500 15/05/2007