Replacing The Dvi / D15 Input - Barco iD H250 Service Manual

5.4.3.4.2

Replacing the DVI / D15 input

Necessary tools
• Torx screwdriver T10
• nut spanner 4mm
How to replace the DVI / D15 input?
1. Remove the input module - See "Removing the input module", page 32
2. Remove the backplane - See "Replacing the backplane", page 34
3. Remove the side screw
Image 5-20
Input module: side screw fixing the DVI / D15 input layer
4. Remove the front nuts
Image 5-21
Input module: front nuts fixing the DVI / D15 input board
5. Take out the DVI / D15 input board
R59770097 ID H250 / H500 15/05/2007
5. Electronic spares and servicing procedures
39