Table of Contents
Advertisement
Item
COLOR MATCHING
MANUAL
MEASURE
•
When EDGE BLENDING is ON or COLOR MATCHING is MANUAL or MEASURE, COLOR ENHANCER in the IMAGE menu
is set to MULTI-SCREEN. In this case, you cannot set any other items than MULTI-SCREEN.
•
The edge blending function can be used with non-directional screens. If you use a directional screen, the areas where images
are overlapped seem discontinuous depending on the viewing angle.
•
The target chromaticity value entered for TARGET DATA in the MEASURE menu is just for guidance. If the obtained result
doesn't match with the colors displayed on the adjoining projectors, adjust the value while viewing the screens.
5.7
FEATURE menu
Overview
IMAGE INSTALL1 INSTALL2 MULTI-
SCREEN
PROJECTOR ID
GROUP ID
PASSWORD FUNCTION
MENU POSITION
CINEMA MODE
LANGUAGE
ADVANCED MENU
RESET ALL
Image 5-17
Item
PROJECTOR ID
GROUP ID
PASSWORD FUNCTION
MENU POSITION
CINEMA MODE
R5905597 PHXX SERIES 20/05/2014
Setting
RESET
OFF
MANUAL
MEASURE
SETTING
RESET
MEASURED DATA
TARGAT DATA
RESET
FEATURE
SIGNAL NETWORK
INFO
ALL
A
DISPLAY INPUT
1.
AUTO
English
ENTER
OK
Setting
ALL
A to Z
DISPLAY INPUT
/
MENU ACCESS
/
SPLASH ID SCREEN
1 (upper left) / 2 (lower
right) / 3 (center)
AUTO
Function
Use to reset the values of EDGE ADJUST
BRIGHT UNIFORMITY CORRECTION
Select this option when the projector is used alone.
Select this option when adjusting colors while viewing the screen to
correct color variations among the projectors.
Select this option when adjusting colors using a measuring instrument
to correct color variations among the projectors.
The test signal is displayed. Make adjustment so that the color tones
of each image match among the adjoining projectors.
Use to reset the value of SETTING
The test signal is displayed. Measure the brightness and chromaticity
of each image using a measuring instrument (chroma meter) and enter
the measurement values.
Use to set the target chromaticity value of each color.
Use to reset the values of MEASURED DATA
in the MEASURE to the defaults.
IMAGE INSTALL1 INSTALL2 MULTI-
FEATURE
SCREEN
ADVANCED MENU
VIDEO SIGNAL
SETUP
SCART INPUT
LAMP WARNING
HIDE OSD
LAMP 1 TIME RESET
LAMP 2 TIME RESET
FILTER TIME RESET
Function
This projector does not support this function.
Use to set the ID number for controlling multiple projectors by groups
for monitoring and control via the SERIAL terminal.
Use to enable or cancel the password lock.
Use to change the position of the menu.
The film mode will be automatically activated when a film source
signal is input.
Select AUTO for normal use.
When flicker occurs on the screen, frame dropping or other incorrect
display occurs, or jaggies on slanting lines are remarkable, select
either FILM or VIDEO, which improves the symptom better.
5. Advanced menu
, BLACK LEVEL
to the defaults.
in the MANUAL to the default.
and TARGET DATA
SIGNAL NETWORK
INFO
AUTO
AUTO
OFF
STANDARD
OFF
OK
OK
OK
and
47
Advertisement
Table of Contents
