Barco PHWU-81B User And Installation Manual page 52

5. Advanced menu
Item
LANGUAGE
ADVANCED MENU
VIDEO SIGNAL
SETUP
SCART INPUT
LAMP WARNING
HIDE OSD
LAMP 1 TIME RESET
LAMP 2 TIME RESET
FILTER TIME RESET
RESET ALL
• CINEMA MODE can be adjusted only when a TV60, TV50, 480i, 576i or 1080i signal is being displayed.
• When SCART INPUT is set to ON, normal computer signals aren't projected.
• Use a commercially available SCART-Mini D-SUB 15-pin cable when connecting this projector with an AV device equipped with
the SCART terminal.
• Some AV devices equipped with the SCART terminal aren't compatible with this projector.
• The RESET ALL process may take some time to complete.
• You cannot carry out RESET ALL for approx. 2 minutes after the lamp switching or the lamp relay operation.
48
Setting
FILM
VIDEO
Different languages
ENTER
AUTO / NTSC / PAL /
SECAM / 4.43NTSC /
PAL-M / PAL-N / PAL-60
AUTO
OFF
3.75% / 7.5%
ON / OFF
STANDARD
SHORT TERM
OFF
ON
OK
OK
OK
OK
Function
Fixed to the film mode.
The film mode will not be activated.
Use to select the language used in the menus.
The ADVANCED MENU is displayed for the following settings.
When AUTO is selected, the appropriate video format is automatically
selected depending on the input signal. If the image isn't displayed
correctly, select the desired video format manually.
Select to change the SETUP mode automatically.
Select to make black lighter.
Select to make black thicker.
When 7.5% is chosen, the brightness is decreased by the setup cancel
function for the U.S. Choose OFF when the image is dark.
Choose ON when connecting the projector with a device equipped
with the SCART terminal that can output RGB signal. SCART terminal
is used mainly in Europe. Choose OFF normally. (Available only for
the input signal from the COMPUTER/COMPONENT VIDEO IN-1
terminal.)
When the lamp operating time exceeds 3000 hours with LAMP MODE
set to LOW, a warning dialog is displayed.
When the lamp operating time exceeds 3800 hours with LAMP MODE
set to LOW, a warning dialog is displayed.
Select this option for normal use.
The auto power-off dialog, lamp warning dialog, and abnormal
temperature dialog aren't displayed.
The LAMP 1 operation time is reset to 0.
The LAMP 2 operation time is reset to 0.
The filter operation time is reset to 0.
The menu settings are reset to the factory defaults (except the
LANGUAGE, PASSWORD FUNCTION, SCREEN, and NETWORK
settings).
R5905597 PHXX SERIES 20/05/2014