Table of Contents
Advertisement
8. Lamp relay
→ Maximum interval
24H
1 WEEK
← key
→ key
DEL key
CLEAR key
→ When the value you entered meets the following conditions, an error dialog box is displayed at the screen center.
-
The value has been cleared by DEL or CLEAR and left blank.
-
The value you entered is out of the setting range.
24H
1 WEEK
-
The value of each item is out of the setting range.
D
H
10.When selecting OK, the setting is completed as the lamp-switching interval stored. However, when selecting CANCEL, the setting
is completed without storing.
→ The display returns the LAMP RELAY menu after selecting OK or CANCEL.
→ The setting you made is applied to NEXT LAMP RELAY in the INFORMATION menu.
Important
•
When you use the projector continuously, the lamp relay may not be performed on time due to errors of the clock function.
•
Immediately after the power-on, during the lamp selection, or during the lamp relay operation, you cannot change the setting
of LAMP SELECT and LAMP RELAY.
•
In the case of continuous projection, the lamps may deteriorate earlier unless they are turned off for 1 hour per week.
•
When using this projector continuously for a long time of period, enable LAMP RELAY.
•
The brightness and color tint vary at the time of lamp switching.
84
24H (24 hours)
7D 00H (7 days and 00 hours)
Shifting the position of enter cursor to the left for each character.
Shifting the position of enter cursor to the right for each character.
Deleting the character in the position of enter cursor for each character.
Deleting all the entered characters.
25H or over
7D 01H or over
8 or over (1 WEEK
only)
25 or over
R5905597 PHXX SERIES 20/05/2014
Advertisement
Table of Contents
