Barco PHWU-81B User And Installation Manual page 99

(d)
Image 10-4
5. Loosen two screws (f) that are securing the lamp box to be removed using a Phillips screwdriver.
2
(f)
Image 10-5
6. Pull the handle.
7. Pull out the lamp box by the handle while holding the projector.
Image 10-6
- Pull the lamp box out of the projector slowly. When the lamp is broken, glass fragments may be scattering by quickly pulling
out the lamp box.
- Do not spill liquid on the removed lamp box or do not place it near any flammable object or where children can reach to prevent
injury or fire.
8. Load a new lamp box securely into the projector in the right orientation.
Image 10-7
9. Put the handle back to the original position.
Note: Make sure that the handle is locked.
10.Tighten two screws (f) of the new lamp box tightly using a Phillips screwdriver.
2
(f)
Image 10-8
Note: Make sure that the screws are tightened firmly.
11. Insert the lamp cover (e) into the projector and tighten two screws (d) on the lamp cover firmly using a Phillips screwdriver.
R5905597 PHXX SERIES 20/05/2014
(e)
1
(f)
1
(f)
10. Lamp replacement
95