Settings Main Menu - Barco CTHD-61B User Manual

5.8 Settings main menu

PIN code:
network :
factory reset:
service :
standby ECO mode
DPMS :
DPMS timeout :
LED indicators mute: Disable all LED indicators on top of the projector. A critical error (status LED
menu timeout:
background:
splash:
baudrate:
39
Protect the projector from usage with a PIN. If enabled the projector will ask for
the PIN at every start up.
Set IP address, Subnet mask and default gateway TCP/UDP port number.
DHCP is supported and is enabled by default, but can be disabled.
Restore all settings to the factory defined values.
End user protected settings. Access PIN code required.
Power saving mode sending the projector into a deep sleep setting when in
standby. Wake up can be performed either by pressing the power button on the
projector/remote control or remotely via the RS232 connector using the ASCII
protocol / wake on LAN via the ethernet. If DPMS is enabled and a source signal
becomes active again the projector will return to normal operation.
When in standby ECO mode, the baudrate of the RS232 communication is fixed
at 19200.
Enable or disable DPMS power saving. This feature is used to automatically
power down the projector if no source is detected for a given period of time
(defined by DPMS timeout). If the projector is powered down in DPMS power
save, it will automatically power back on if a valid source is acquired.
Set the period of time before the projector automatically enters DPMS mode.
DPMS must be enabled for this menu item to activate.
flashing RED) will still be enabled.
The time interval before the OSD is automatically disabled. Option of "never" is
available if the OSD is never to time out.
Gives a choice between white, gray or black background color.
Possibility to choose between logo or black for the startup splash screen.
Presents alternative bauderate settings:
4800, 9600, 19200, 38400, 57600, 115200