Settings Main Menu - Barco Orion 1080 Safety And Users Manual

5.8 Settings main menu

PIN code:
network :
factory reset:
service :
standby ECO mode
DPMS :
DPMS timeout :
LED indicators mute:
menu timeout:
background:
splash:
baud rate:
41
Protect the projector from usage with a PIN. If enabled the projector will ask for the
PIN at every start up.
Set IP address, Subnet mask and default gateway TCP/UDP port number.
DHCP is supported and is enabled by default, but can be disabled.
Restore all settings to the factory defined values.
End user protected settings. Access PIN code required.
Power saving mode sending the projector into a deep sleep setting when in standby.
Wake up can be performed either by pressing the power button on the projector/
remote control or remotely via the RS232 connector using the ASCII protocol / wake on
LAN via the Ethernet. If DPMS is enabled and a source signal becomes active again the
projector will return to normal operation.
When in standby ECO mode, the baud rate of the RS232 communication is fixed at
19200.
Enable or disable DPMS power saving. This feature is used to automatically power
down the projector if no source is detected for a given period of time (defined
by DPMS timeout). If the projector is powered down in DPMS power save, it will
automatically power back on if a valid source is acquired.
Set the period of time before the projector automatically enters DPMS mode. DPMS
must be enabled for this menu item to activate.
Disable all LED indicators on top of the projector. A critical error (status LED flashing
RED) will still be enabled.
The time interval before the OSD is automatically disabled. Option of "never" is
available if the OSD is never to time out.
Gives a choice between white, gray or black background color.
Enable or disable manufacturer logo or black for the startup splash screen.
Presents alternative baud rate settings:
4800, 9600, 19200, 38400, 57600, 115200