Cold-Shoe Connector For Lighting Accessories; Moisture Detector - Fantasea Line FRX100 III Housing Instruction Manual

5. To use, slide right hand from back side to front of the
Hand Strap with knuckles protruding slightly out of the
front (lens side) of the strap (image #25). Have it snug
but not too tight, to allow for control manipulation.
6. Always use the wrist lanyard with the hand strap.
7. When opening or closing the housing, you may need to
loosen the Hand Strap slightly in order to rotate it
forward to allow for easier opening and closing of the
latch.
8. When closing the housing, take special notice and care
not to close part of the Hand Strap inside the housing,
which will interfere with the watertight seal of the housing.
9. Make sure to rinse the Hand Strap in fresh water and then dry after every use. Store in a dry, shaded
area.

COLD-SHOE CONNECTOR FOR LIGHTING ACCESSORIES

The Cold-Shoe Mount featured on the housing enables mounting a flash, video light, night dive torch or
focus light on top of the housing by using a standard Cold-Shoe connector mount.

MOISTURE DETECTOR

The FRX100 III Housing comes with a Moisture Detector installed inside (on the inner side of the housing
latch dial – see image #10). Moisture detectors are very sensitive, so whenever moisture is detected by the
sensor located at the bottom of the housing, the moisture detector LED light begins flashing and a warning
alarm starts beeping, thereby alerting the user of a possible leak. For further instructions, please refer to
the Fantasea Moisture Detector section (page 28).
Image #23
24
FRX100 III Housing Instruction Manual 20141005
Image #24
Image #25