Housing Hand Grip Strap - Fantasea Line FRX100 III Housing Instruction Manual

filters can be mounted directly on the housing lens port, and can also be installed inside BigEye and
SharpEye accessory lenses.

EyeGrabber Lens Holders: Attach to Flex or Ball & Joint arms, enabling safe, secure and easily
accessible storage for your lens accessories when not in use during the dive.

HOUSING HAND GRIP STRAP

The FRX100 III Housing features two hand strap loops on the "latch" side of the housing, which enable the
attachment of an optional hand grip strap for the housing in order to improve hand grip, especially when
using the housing during extreme sports activities.
Installing the Fantasea Hand Strap (Cat. No. 11188) on the Housing
1. Pull the narrow nylon Velcro strip through top of lower housing ring (below the locking latch) in a
downward direction to the end of the strip (images #20 and 21).
2. Place the wide flat Velcro mid-section over the locking latch and pull the thin Velcro strip over the
top of this mid-section and through the upper
housing ring from bottom to top all the way through
(image #22).
3. Double back the thin nylon Velcro strip and secure it
tight to the top of the Velcro strip previously
inserted (same strip) and press down. Then cover
with the wide flap (should be on the right side) over
the thin Velcro strips (image #23 on the following
page).
4. Place top flap (with logo) over bottom flap and press to close (images #24 and 25 on the following
page).
Image #20
23
Image #21
FRX100 III Housing Instruction Manual 20141005
Image #22