Fantasea Moisture Detector; Identification Of Parts - Fantasea Line FRX100 III Housing Instruction Manual

FANTASEA MOISTURE DETECTOR

Note!
The alarm unit of the Moisture Detector is installed inside the
housing, opposite the latch dial (image #26 – item A). The Moisture
Sensor unit is installed just under the camera (image #26 – item B). A
thin wire connects these units. Moisture detectors are very sensitive,
so whenever moisture is detected by the sensor, the moisture
detector LED light begins flashing and a warning alarm starts
beeping, thereby alerting the user of a possible leak.

IDENTIFICATION OF PARTS

Electrical wires
Electrical plug
Wrapped Alarm Unit
Never soak or wash the interior of the housing with water. This will set off
the alarm in a way that cannot be disabled, eventually causing irreparable
damage to the electronic unit!
The moisture detector is a bonus add-on component and not an integral
part of the housing. Accordingly, it is not part of the housing warranty
coverage. The moisture detector has no warranty coverage.
Black tape wrap
Sound
Alarm
Cylinder
Red LED light
Battery
compartment
Battery removal
Unwrapped Alarm Unit
groove
Moisture Sensor Unit
FRX100 III Housing Instruction Manual 20141005
28
A
B
Image #26
3V Lithium
#CR1220 Battery
Sensor