Removing The Camera From The Housing - Fantasea Line FRX100 III Housing Instruction Manual

5. Gently try pulling the back door away from the front door. If the housing is properly closed, it
should be impossible to open the back door.
6. Visually inspect the black O-ring through the transparent back door for proper closure. Make
sure it isn't twisted or out of the groove and that no foreign matter has been caught in the seal,
such as secure lines, sand, grit, hairs or any other foreign substance.
7. Turn the camera on and check that the
extended camera lens does not catch or bend
the black rubber seat on the inside of the lens
port. It is vital that this rubber seat does not
disturb the lens (image #14).
8. Test housing control buttons to make sure
that the camera was properly installed inside
the housing and that nothing interferes with
normal operation of the camera. It is
recommended to take a few images once the
camera has been installed inside the housing
and prior to the dive in order to ensure
proper operation.
9. If making use of the internal camera flash, install the removable
flash diffuser on the housing and attach the flash diffuser quick release secure string in order to
avoid losing it underwater. Please refer to the section "Using the Built-in Camera Flash" for
further information.
10. Prior to diving with the housing, submerge it in a shallow tub of water or rinse tank. Carefully look at
the housing to make sure no bubbles are escaping from it and that no water is entering.

REMOVING THE CAMERA FROM THE HOUSING

1. After use, thoroughly rinse the housing fresh water. Prior to opening the housing, make sure
both your hands and the housing are clean and dry. It is recommended to have a clean, dry and
soft towel handy in order to dry your hands and the water drops on the housing.
2. When opening the housing, it is important to hold it so the lens port is facing down. This will
prevent the camera from slipping out of the housing while being opened.
3. Open the housing as described in the section "Opening the Housing" and carefully remove the
camera from the housing. Take sufficient care that no water drips from your hair and body onto
the housing and camera.
FRX100 III Housing Instruction Manual 20141005
18
Image #14