Table of Contents
Advertisement
D-Series Class-A
SLIDEOUT EMERGENCY
RETRACTION – ELECTRIC
(Front Slideout Room)
Crank-In Mode
If the room will not retract using the buttons
and the mechanism is apparently malfunctioning,
you may need to manually crank the room in to
the travel position. The cranks are stored on clips
on the wall of an exterior storage compartment.
Slideout Cranks (typical)
The crank sockets are located behind exterior
storage compartment doors.
Insert the crank handle into the socket and
align the notches in the crank handle with the
pins on the drive shaft as shown.
It may be necessary to move the handle
slightly from side to side to fit it onto the shaft.
The crank handle will only move the arm that it
is inserted into. Consequently you will need to
alternate between each crank handle on each side
to move the room in or out. If help is available a
second person cranking on the other handle
simultaneously will greatly speed up the process.
At no point in the cranking process should you let
one side get more than 2 inches (50 mm) ahead of
SLIDEOUT / LEVELING
the other. The most effective way to retract the
room using a single person is to crank one side
ahead of the other, then crank the other side in
("walk" the room in).
CAUTION
Never let one side get more than 2 inches
(50 mm) ahead of the other while
retracting.
Further Information
See the Slideout Room operating guide
included in your InfoCase for further instructions
and troubleshooting information.
SLIDEOUT EMERGENCY
RETRACTION/ BEDROOM –
ELECTRIC
–If Equipped
Crank-In Procedure
1. Locate the tools in the right front side storage
compartment - a ratchet wrench, a hex-end
shaft and an extension shaft. (The ratchet
wrench may be packaged in the InfoCase.)
2. Locate the small, round access hole in the bed
base at the foot of the bed.
SECTION 10
10-5
Advertisement
Table of Contents
