Table of Contents
Advertisement
SECTION 3
DRIVING YOUR MOTOR HOME
FOLD-DOWN DINETTE SEAT
(Models without front slideout and with
dinette seat directly behind driver or
passenger front seat)
On some models, the dinette seat located
directly behind the driver or passenger front seat
must be folded down to allow front seat reclining.
Folding Dinette Seat Back
• Remove dinette seat backrest cushion
• Unfasten bolt latch at aisle side of seat)
• Fold dinette seat backrest down to recline front
seat
*Typical view- your coach may vary according
to model and floorplan
SEAT BELTS
Seats intended for occupancy while the
vehicle is in motion are equipped with seat belts
for the protection of the driver and passengers.
3-2
Lap Belts
The lap belts must be worn as low as possible
and fit snugly across the hip area. Always sit
erect and well back into the seat. To gain full
protection of the safety belt, never let more than
one person use the same safety belt at any one
time, and do not let the safety belts become
damaged by pinching them in the doors or in the
seat mechanism. After any serious accident, any
seat belts which were in use at the time must be
inspected and replaced if necessary.
1- Insert tab into buckle
slot until it 'clicks' and is
locked
2- Pull strap to tighten
Adjustment
To lengthen belt, swivel the tab end at a right
angle to belt and pull strap to desired length. To
shorten, pull loose end of belt.
To Fasten
Be sure belt is not twisted. Grasp each part of
the belt assembly and push tongue into buckle.
Adjust to a snug fit by pulling the loose end away
from the tongue.
To Release
Press button in center of buckle and slide
tongue out of buckle.
D-Series Class-A
3- Press to
release
Advertisement
Table of Contents
