Table of Contents
Advertisement
SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
SLIDEOUT EMERGENCY
RETRACTION – ELECTRIC
(Front Slideout Room)
Crank-In Mode
If the room mechanism is malfunctioning and
will not retract using the buttons, you will need to
manually crank the room in to the travel position.
(The room can also be cranked out into the
extended position using this method if
necessary.)
The slideout crank tools are stored in clips on
the wall of an exterior storage compartment.
Slideout Cranks (Typical)
The crank sockets are located behind covers
on the lower ends of the room on the outside of
the coach. Your coach may have one of the two
types of covers shown.
Type A (Twin Arm ) - Covers on lower face of
room (Photo 1A)
Pry out the snap-in screw cover (Photo 2A)
and remove the screw to take off the cover plate.
(The crank socket is shown in Photo 3.)
10-6
Type B (Single Arm) - Cover mounted beneath
face of slideout room
Remove the four bolts that fasten the cover to
the arm – two on each side. (The crank socket is
shown in Photo 3.)
Advertisement
Table of Contents
