Cb Radio Power Wiring; Engine Access - Winnebago Chalet Manual

Hide thumbs Also See for Chalet:
Table of Contents

Advertisement

SECTION 3
DRIVING YOUR MOTOR HOME
listening while parked. This prevents accidental
draining of the chassis battery by prolonged use
of the radio.
NOTE:The Aux. Battery Disconnect switch must
be on while listening to the dash radio
because the audio relay is powered by
house batteries. If the Aux Batt switch is
off, the speakers will not emit sound.
Radio Power Switch
• Press ENGINE to listen to the radio while
parked without the ignition key on.
• Press HOUSE to listen while driving.

CB RADIO POWER WIRING

Your coach is pre-wired for CB radio power
connection. The wires are located beneath the
dash to the left of the steering wheel.
Look for a pair of wires, yellow (+) and white
(-), with connectors and flag labels, suspended
from the wiring harness.
CB Power Wires
(in plastic sheath)
typical view - your coach
may differ slightly
3-10

ENGINE ACCESS

Hood
Insert the tamper-resistant hood key into the
hood locks and turn them to the right (clockwise)
to unlock the hood.
Swing the hood outward and down. Do not let
hood drop.
To close the hood, lift and swing inward. Turn
key locks to the left (counterclockwise) to lock
hood closed.
With the hood open, the engine oil dipstick,
oil fill, radiator fill, power steering reservoir and
windshield washer reservoir are accessible.
Some chassis also allow access to the engine
air filter element.
Engine Cover
To remove the engine cover, insert the
supplied hex wrench into the hole in the rear
top or edge of the engine cover.
Turn the hex wrench to the left
(counterclockwise) to unlatch.
Unlatch
NOTE: There may also be screws to remove at
the lower front corners.
Lift the rear end of the cover upward and slide
rearward, then pull the cover from the
opening.
NOTE: On some models the beverage tray (if
equipped) may need to be removed to
provide additional clearance to extract
the engine cover.
If the beverage tray has a drawer, it must
be removed to expose the fasteners that
hold the tray to the motor cover.
D-Series Class-A

Advertisement

Table of Contents
loading

Table of Contents