Table of Contents
Advertisement
SECTION 8
ENTERTAINMENT
Raising Antenna to Operating Position
Turn elevating crank clockwise in "UP"
direction until some resistance to turning is noted
(about 13 turns). Antenna is now in operating
position.
Turn amplifier power switch "ON" to receive TV
signal.
Rotating Antenna for Best Picture
Make sure antenna is in the "UP" position.
Pull down on directional handle using both hands
until it disengages ceiling plate and rotate for best
picture and sound on TV set.
Lowering Antenna to Travel Position
Rotate antenna until pointer on directional
handle aligns with pointer on ceiling plate.
Turn elevating crank (counterclockwise) in
"DOWN" direction until resistance is noted
(about 13 turns). Antenna is now locked in travel
position. Turn amplifier power switch "OFF".
8-6
CAUTION
Always align directional handle to
"DOWN" position before lowering.
Never partially raise or lower antenna.
Antenna must be raised fully up into
operating position or lowered fully down
into travel position.
TV SIGNAL AMPLIFIER
The TV signal amplifier is built into the
antenna and can be turned on or off with a power
switch inside the coach.
The amplifier power switch is located on a
wall plate or on the optional video selection
system in the video center.
Wall plates are mounted in various locations
depending on floorplan. Some of these wall
plates are not easily visible and may be in one of
the following locations.
•
Inside front overhead TV cabinet, if equipped.
•
Inside or underside of a side overhead cabinet.
•
In the optional entertainment center on the
outside of the coach.
TV Signal Amplifier Power Switch on models
without video selection system
(Some models may also have a 12-volt outlet
and/or coaxial jack on the wall plate.)
D-Series Class-A
Advertisement
Table of Contents
