Firmware Version - ADJ monster beam User Instructions

Hide thumbs

Table of Contents

Enlarged version

Monster Beam

ENTER.

2. Either "Master/Slave", "Blackout", or "Last State" will be dis-

played. Choose an operating mode you would like the unit to

start up in when power is applied or the DMX signal is lost.

• Master/Slave - If the DMX signal is lost or power is applied, the

unit will automatically go into Master Slave mode.

• Blackout - If the DMX signal is lost or power is applied, the unit

will automatically go into stand by mode.

• Last State - If the DMX signal is lost the fixture will stay in the

last DMX set up. If power is applied and this mode is set, the unit

will automatically go into the last DMX set up.

3. Press ENTER to confirm your desired set up.

Back Light

- With this function you can make the back-

light automatically turn off after one minute.

1. Press the MENU button until "Back Light" is displayed, press

ENTER.

2. Either "ON" or "OFF" will now be displayed. Press the UP or

DOWN buttons to select "ON" to keep the backlight on at all

times, or "OFF" to allow the backlight to turn off after 2 minutes.

Press any button to turn the backlight on again.

3. Press ENTER to confirm.

Auto Test

- This function will run a self test program.

1. Press the MENU button until "Auto Test" is displayed, press

ENTER.

2. The fixture will now run a self test. Press the MENU button to

exit.

ADJ Products, LLC - www.adj.com - Monster Beam User Manual Page 10

System Menu

Monster Beam

Fixture Time

running time of the unit.

1. Press the MENU button until "Fixture Time" is displayed,

press ENTER.

2. The running time of the fixture will now be displayed. Press

MENU to exit.