Fuse Replacement | Software Updates - ADJ FOCUS WASH 400 User Manual

Disconnect the unit from the power source, then use a flat head screw driver to unscrew the fuse
holder located above the DMX ports. Remove the bad fuse and replace with a new one, then screw
the fuse holder back in. Replace only with a new fuse of the same type and rating.
ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THIS FUNCTION! NOTE ALL MENU SET-
TINGS BEFORE UPDATING SOFTWARE!
FIXTURE SOFTWARE CANNOT BE DOWNGRADED!
DOWNLOAD FIXTURE SOFTWARE TO PC ONLY! (NO MAC SUPPORT)
PLEASE CONTACT ADJ CUSTOMER SERVICE FOR FURTHER INFORMATION.
1. Contact ADJ customer service to obtain the updated software. Download software to a USB
flash drive. In order to minimize the risk of downloading the incorrect software to your device,
make sure that the desired update files are the only files on the USB flash drive.
2. Disconnect any DMX connections from your device. Insert the USB flash drive into the service
port on your device.
3. Use the display screen control panel to navigate to Personality > Service > USB Port Power.
See the System Menu section of this manual for detailed instructions. Enter the passcode when
prompted, and switch the USB Port Power setting to ON.
4. Highlight the desired file and press ENTER to select it and begin the download.
5. The unit will now update, run an automatic software check, and reset. This may take some time.
6. Repeat this process for each software update file.
7. Verify by navigating to Information > Software Version and confirming that the correct software
version number is shown there (see the System Menu section of this manual for detailed instruc-
tions).
ADJ Products, LLC - www.adj.com - Focus Wash 400 User Manual Page 34
FUSE REPLACEMENT
SOFTWARE UPDATES