Removal Of The Control Board - Flavel Emberglow Classic RC User Manual

4.5 REMOVING THE CONTROL BOARD
a) Disconnect the appliance from the gas supply.
b) Remove the glass front panel as descibed on page 9, (fig. 2)
c) Remove the coals and fuel-bed matrix. Pull the fire forwards and tilt fire
onto its back to allow access to control board underneath (situated in
centre).
d) Disconnect the wiring looms
e) Replace in reverse order, re-connect to gas supply and carry out a gas
tightness test
Note : Prior to replacing the oxypilot on this product due to suspected
failure of the component, please remove all debris that has collected on
the lint guard of the oxypilot itself.
PARTS SHORTLIST
Replacement of any parts must be carried out by a competent person such as a
CORGI registered gas installer. The part numbers of the replaceable parts are as
follows, these are available from specialist spares stockists whose details can be
found on our web site, www.bfm-europe.com, in the 'stockist' section.
Coal set
Fuelbed
Gas valve (NG)
Rear Fibre board
Glass Assy (Front)
FC-P085332 ODS Pilot (NG)
B-123570 EDB Control Board
B-106790 Battery Holder
B-65320 Remote Handset
SFA-085165
23
B-49710
B-106800
B-106820
B-63600