Flavel Emberglow Classic RC User Manual page 29

SPILLAGE MONITORING SYSTEM
This appliance is fitted with a spillage monitoring system which shuts down the fire
if the evacuation of combustion products from the fire is affected by a partially or
fully blocked flue.
If this system operates the fire will go out. If this occurs, leave the fire for at least
three minutes then follow the lighting procedure as described in the previous
section. In the event of repeated operation a CORGI registered gas installer
must be called to investigate and rectify the cause.
Note : Prior to replacing the oxypilot on this product due to suspected
failure of the component, please remove all debris that has collected on
the lint guard of the oxypilot itself.
CLEANING - WARNING
Before attempting any cleaning operation ensure that the fire has been allowed to
fully cool.
CLEANING THE FUELBED / COALS
We do not recommend regular cleaning of the fuelbed ceramics as these are
fragile and damage may result. None of these parts must be washed or
exposed to any cleaning agents or water.
Any damaged parts must be replaced by contacting your dealer or telephoning
BFM Europe Ltd. on the number stated on the rear cover of this book. The
fuelbed ceramics must only be replaced with a complete and genuine replacement
set and the fire must never be run with the wrong number or damaged coals. The
fuelbed ceramics must be carefully re-assembled as stated in pages 7 - 9 of this
book.
CLEANING THE OUTER CASTINGS
Dusting is normally all that is required. But where extra cleaning is necessary, use
a damp cloth.
6