Removal Of The Control Board - Flavel REGENT L.F.E. RC Installation, Maintenance & User Instructions

4.5 REMOVING THE CONTROL BOARD
a) Disconnect the appliance from the gas supply. Remove the front bezel
by unscrewing the 2 retaining screws from the bottom face.
b) Remove the coals and fuel-bed matrix. Pull the fire forwards and tilt fire
onto its back to allow access to control board underneath (situated in
centre). Remove the black painted heat shield by removing the L/H/S &
R/H/S retaining screws.
c) Disconnect the wiring looms
d) Replace in reverse order, re-connect to gas supply and carry out a gas
tightness test
22