Table of Contents
Advertisement
Fig. 19
2 off L/H Burner
Retaining Screws
e)
Remove the four burner retaining screws as indicated in Fig. 19 above
f)
Slide the burner assembly to the right, off the injector and remove the
from the firebox.
4.3
REMOVING THE CONTROL VALVE FROM THE FIRE
a)
Disconnect the appliance from the gas supply.
b)
Remove the glass front panel as descibed on page 9, (fig. 2)
c)
Remove the coals and fuel-bed matrix. Pull the fire forwards and tilt fire
onto its back to allow access to valve underneath (situated in centre)
d)
Disconnect the pilot pipe, inlet pipe,valve to injector pipe and
thermocouple connection.
e)
Replace in reverse order and carry out a gas tightness test
4.4
REMOVING THE ODS- PILOT ASSEMBLY
Note : Because this appliance is fitted with an atmosphere sensing ODS-pilot
it is not possible to replace the thermocouple separately, because the
thermocouple position is factory set to a tight tolerance. Any replacement of
parts on the pilot requires a complete new pilot assembly.
a)
Remove the pilot retaining screws as described in section 4.2 d) &
fig. 18
b)
Disconnect the pipe pipe and push fit ignition lead
c)
Replacement new ODS in reverse order, and carry out a gas tightness
test.
22
2 off R/H Burner
Retaining Screws
Hide quick links:
Advertisement
Table of Contents
