Dimm Module Installation - EPOX MU-8KHA User Manual

DIMM Module Installation

Figure 7 displays the notch marks and what they should look like on your DDR
DIMM memory module.
DIMMs have 184-pins and one notche that will match with the onboard DDR
DIMM socket. DIMM modules are installed by placing the chip firmly into the
socket at a 90 degree angle and pressing straight down (figure 8) until it fits tightly
into the DIMM socket (figure 9).
To remove the DIMM module simply press down both of the white clips on either
side and the module will be released from the socket.
Figure 7
Figure 8
DIMM Module clip before installation
Figure 9
DIMM Module clip after installation
CENTER KEY ZONE
(2.5 V DRAM)
Installation
Page 3-7