Advertisement
Quick Links
ISA/PCI Motherboard with Onboard AGP
VGA, PCI Audio, PCI IDE and Super
Multi-I/O
TRADEMARK
All products and company names are trademarks or
registered trademarks of their respective holders.
These specifications are subject to change without notice.
Manual Revision 1.0
May 10, 1999
Advertisement
Related Manuals for EPOX MVP4M
Summary of Contents for EPOX MVP4M
- Page 1 ISA/PCI Motherboard with Onboard AGP VGA, PCI Audio, PCI IDE and Super Multi-I/O TRADEMARK All products and company names are trademarks or registered trademarks of their respective holders. These specifications are subject to change without notice. Manual Revision 1.0 May 10, 1999...
- Page 2 Supports (1) 16 bit ISA slots, (3) 32 bit PCI slots, (1) AMR Slot and provides (2) independent high performance PCI IDE interfaces capable of supporting PIO Mode 3/4 and Ultra DMA 33/66 devices. The MVP4M supports (3) PCI Bus Master slots and a jumperless PCI INT# control scheme which re- duces configuration confusion when plugging in PCI card(s).
- Page 3 Features MVP4M • Supports ring-in feature (remote power-on through external modem, allows system to be turned on remotely. • Resume by Alarm - Allows your system to turn on at a preselected time. • Supports CPU Hardware sleep and SMM (System Management Mode).
- Page 4 Installation MVP4M MVP4M Detailed Layout Figure 1 Page 4...
-
Page 5: Installation
MVP4M Installation The following must be completed before powering on your new system: Configure Jumpers System Memory Configuration Device Connectors We design this motherboard with the two DIP Switch to make your install fast and easy. Note: The DIP Switch as depicted as shown (Figure 1) in their correct physical orientation. - Page 6 Installation MVP4M CPU Type Multiplier Pentium/MMX Clock Cyrix /IBM AMD K5/K6 6x86MX/MII IDT-C6 166MHz PR200 66MHz PR233 75MHz PR266 83MHz 2.5X PR300 95MHz 250MHz PR366 100MHz 200MHz PR266 66MHz PR300 75MHz 250MHz PR333 83MHz PR400 95MHz 300MHz *PR433 100MHz 233MHz...
- Page 7 MVP4M Installation The MVP4M supports (2) 168-pin DIMMs (Dual In-line Memory Module). The DIMMs can be either EDO (Extended Data Out) or SDRAM (Synchronized DRAM). The DIMMs may be installed using just one chip. • We recommend using SDRAM DIMM can not mixing with EDO DIMM modules.
- Page 8 Installation MVP4M Please install the motherboard into the chassis. Now that your motherboard is installed you are ready to connect all your connections (figure 6). parallel port Joystick/Midi PS/2 Mouse USB port PS/2 KEYBOARD COM1 VGA1 Speaker Line_in Figure 6 J2,J3: Chassis Panel Connector •...
- Page 9 MVP4M Installation (This is connected to the power button on the case. Using the Soft-Off by Pwr-BTTN feature, you can choose either Instant Off (turns system off or 4 sec delay (you need to immediately), hold the button down for 4 seconds before the system turns off).