Super Io Device - EPOX MU-8KHA User Manual

BIOS

Super IO Device

Onboard FDC Controller: Select Enabled if your system has a floppy disk
controller (FDC) installed on the system board and you wish to use it. If you
install and-in FDC or the system has no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Onboard Serial Port 1/2: Select an address and corresponding interrupt for the
first and second serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART Mode Select: This filed allows the users to configure what IR mode the
2nd serial port should use. The default is Normal.
The choice: Normal, IrDA and ASKIR.
RxD, TxD Active :This field configures the receive and transmit signals
generated from the IR port. The default is Hi Lo (when UART Mode Select is
not set to Normal).
The choice: Hi Hi, Hi Lo, Lo Hi, and Lo Lo.
IR Transmission delay: This item allows you to enabled/disable IR transmis-
sion delay.
The choice: Enabled, Disabled.
UR2 Duplex Mode: This item allows you to select IR half/full duplex function.
The choice: Half, Full.
Page 4-14