How To Control The Unit - ACME LED-MS50A User Manual

blink. Use DOWN and UP button to adjust the home position of the Pan, Tilt, color, Gobo1, R-Gobo, Gobo2,
Prism, R-Prism, or Focus. Once the position has been selected, press the ENTER button to setup, to go
back to the functions without any change press the MENU button again. Hold and press the MENU button
about one second or wait for one minute to exit the menu mode.

4. How To Control The Unit

You can operate the unit in three ways:
1. Master/slave built-in preprogram function
2. Easy controller
3. Universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address setting will be effect
at once. Every time you turn the unit on, it will show "LED-MS50" on the display and move all the motors to
their 'home' position and you may hear some noises for about 20 seconds. After that the unit will be ready
to receive DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to give an automatic,
sound activated, synchronized light show. This function is good when you want an instant show. You have
to set the first unit in master mode Show Mode and select show 1 or show 2 or show 3 or show 4 mode.
Its DMX input jack will have nothing plugged into it, and Its master LED will be constantly on and sound
LED will flash to the music. The other units will have to set in slave mode and select Slave 1 (normal) or
Slave 2 (2 light show) mode, Their DMX cables plugged into the DMX input jacks (daisy chain) and the
slave led lights will constantly on.
2-light show
In slave mode, Slave 1 means the unit works normally and Slave 2 means 2-light show. In order to create
a great light show, you can set Slave 2 on the second unit to get contrast movement to each other, even if
you have two units only.
4.2 Easy Controller
The easy remote control is used only in master/slave mode. By connecting to the 1/4" microphone jack of
the first unit, you will find that the remote controller on the first unit will control all the other units in Stand by,
and Mode selection.
Stand By Blackout the unit
Function 1. Sync. Strobe
2. Async strobe
3. Sound Strobe
Mode Sound (LED OFF)
4.3 DMX Controller
By using a universal DMX controller to control the units, you will need to set DMX address from 1 to 512 so
that the units can receive DMX signal.
Press the MENU button up to when the DMX Address is showing on the display. Pressing ENTER button
and the display will blink. Use DOWN and UP button to change the DMX512 address. Once the address
has been selected, press the ENTER button to setup, to go back to the functions without any change press
Show 1. Press to select color
1-4 2. Hold to select gobo
Show (LED LED ON
Slow Blinking)
10E