Figure 7-161. Pim Interface Configuration Page; Table 7-129. Pim Interface Configuration Page Parameters - Supermicro SBM-GEM-X2C+ User Manual

Table 7-128. PIM Component Configuration Page Parameters (Continued)
Parameter
BSR Address
BSR Expiry Time
Interfaces
Clicking the I
NTERFACES
(Figure 7-161). The parameters for this page are shown in

Table 7-129. PIM Interface Configuration Page Parameters

Parameter
Interface
Component ID
Hello Interval (Seconds)
Join Prune Interval
(Seconds)
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Description
This parameter specifies the IP address of the bootstrap router for the local
PIM region, which is a read-only field.
This parameter indicates the minimum time remaining before the bootstrap
router in the local domain is declared down, which is a read-only field.

Figure 7-161. PIM Interface Configuration Page

tab brings up the PIM I
Description
This parameter specifies the interface index.
This parameter specifies a number uniquely identifying the component.
This parameter specifies the time interval between two successive Hello
messages being sent by PIM on this interface.
This parameter specifies the time interval between two successive Join/
Prune messages being sent by PIM on this interface.
C
NTERFACE
7-181
page
ONFIGURATION
Table 7-129.