Viewing Diagnostic Codes - Polaris 2009 RANGER 700 Service Manual

ELECTRICAL
To enable or disable the service interval:
1. Enter the diagnostic mode.
2. Toggle to the service interval screen.
3. Press and hold the mode button for about seven (7) seconds,
until either ON or OFF appears in the Rider Information
Display, depending on your preference.
To reset the service interval:
1. Enter the diagnostic mode.
2. Toggle to the service interval screen.
3. Press and hold the mode button for 2-3 seconds, until the
wrench icon flashes. Release the button.
4. Press and release the mode button once to advance the
setting by one hour. Press and hold the mode button to
advance the hours quickly.
NOTE: If you scroll past the intended number, press
and hold the button until the hours cycle back to
zero.
5. When the desired setting is displayed, wait until the wrench
icon stops flashing. The new service interval is now
programmed.
Miles / Kilometers Toggle
The display in the tripmeter and odometer can be changed to
display either standard or metric units of measurement.
1. Enter the diagnostic mode.
2. Toggle to the screen that displays either kilometers (KM)
or miles (MP).
3. Press and hold the mode button until the letters flash, then
press and release the button once. When the display stops
flashing, the mode has been set.
10.10

Viewing Diagnostic Codes

Use the following procedure to view diagnostic blink codes
(failure codes) from the EFI module:
NOTE: Refer to Chapter 4 "Electronic Fuel Injection"
for a complete list of Diagnostic Blink Codes.
1. Engage the parking brake.
2. Stop the engine.
3. Turn the key switch to the ON position.
4. Turn the key switch off and on three times in less than five
seconds, then leave the switch on. The word "Wait" will
appear on the screen along with a flashing "Check Engine"
light.