Seat / Head Rest - Polaris 2009 RANGER 700 Service Manual

4x4 crew / 6x6

Table of Contents

BODY / STEERING / SUSPENSION

SEAT / HEAD REST

Seat Back / Head Rests

Fasten the seat back to the rear cab frame(s) using the Torx-head screws. NOTE: For seats that have staples visible from

the rear, the seat back cover will need to be placed between the rear cab frame and seat back assembly. Tighten all Torx-

head fasteners to 18-20 in. lbs. (2-2.5 Nm).

Install the headrests on the cab frame using 1/4"-20 x 1" bolts, washers, and 1/4"-20 Nyloc nuts. Place the washers between

the bolt heads and headrest as shown below. Torque bolts to 10 in. lbs. (1.1 Nm).

Check all screws and fasteners for proper torque and installation.

Table of Contents