Polaris 2009 RANGER 700 Service Manual page 187

CLUTCHING
NOTE: Use Bushing Tool PA-47336.
8. Install nut (C) onto end of puller rod and hand tighten. Turn
puller barrel to increase tension on sheave if needed. Using
a hand held propane torch, apply heat around outside of
bushing until tiny smoke tailings appear.
9. Turn sheave counterclockwise on puller rod until it comes
free. Lift sheave off puller.
10. Remove nut from puller rod and set aside.
11. Pull bushing removal tool and adapter from puller rod.
Remove bushing from tool and discard.
Drive Clutch Bushing Installation
1. Place main adapter (Item 8) on puller.
Puller Tool (A,B)
Side "A" toward
sheave
Bushing
Main Adapter
(8)
2. Apply Loctite™ 609 evenly to bushing bore inside
moveable sheave.
3. Set bushing in place on sheave.
4. Insert installation puller tool (Item A/B) with "A" side
down, into center of bushing.
NOTE: 700 EFI Clutch - Use Bushing Tool PA-47336.
5. With towers pointing upward, slide sheave, bushing and
tool onto puller rod.
6. Install nut on puller rod and hand tighten. Turn barrel to
apply additional tension if needed.
7. Turn sheave counterclockwise, making sure bushing is
drawn straight into bore. Continue until bushing is seated.
8. Remove nut from puller rod and set aside.
9. Remove sheave from puller.
10. Remove installation tool.
6.18
Cover Bushing Removal
1.
Nut (C)
2.
3.
4.
5.
6.
Piston Pin
Puller
7.
8.
Cover Bushing Installation
1.
2.
3.
4.
5.
6.
Install main adapter (Item 8) on puller.
Removal Tool
(3)
Main
Adapter (8)
Install adapter reducer (Item 9).
From outside of clutch cover, insert removal tool (Item 3)
into cover bushing.
With inside of cover toward vise, slide cover onto puller.
Install nut onto puller rod and hand tighten. Turn puller
barrel to increase tension as needed.
Turn clutch cover counterclockwise on puller rod until
bushing is removed and cover comes free.
Remove nut from puller rod and set aside.
Remove bushing and bushing removal tool from puller.
Discard bushing.
Apply Loctite™ 609 evenly to bushing bore in cover.
Working from inside of cover, insert new bushing and
bushing installation tool into center of clutch cover.
With main adapter on puller, insert cover onto puller rod,
placing outside of cover toward vise.
Install nut on rod and hand tighten. Turn puller barrel to
apply more tension if needed.
Turn clutch cover counterclockwise on puller rod until
bushing is seated.
Remove nut from puller rod. Take installation tool and
clutch cover off rod.
Nut (C)
Adapter Reducer
(9)
Piston Pin
Puller