35. Install the gear/stator housing gasket onto he crankcase.
36. Secure the gear / stator housing cover to the crankcase with
the cover bolts.
Torque bolts in proper sequence to
specification. Remove seal protectors from the shaft ends
once the cover is secure.
Gear/Stator Housing Bolt Torque:
96 ± 3 in. lbs. (10.85 ± 0.35 Nm)
*Torque in proper sequence
Gear / Stator
Housing Gasket
PA-45401
PA-45658
= T
NOTE: Before assembly, clean the bolts and bolt
holes with Primer N (PN 2874275) to remove any
debris.
This will ensure proper sealing when
installing bolts.
37. Install shaft seal with ceramic surface facing inward.
38. Install water pump impeller (P). Secure the impeller with
the washer and a new nylok nut (Q). Torque the nut to
specification.
P
Water Pump Impeller Nut Torque:
108 ± 6 in. lbs. (6.8 ± 0.68 Nm)
ENGINE
Q
= T
3.53
3