Hdd Cover, Hdd Block And Hdf Circuit Board [For Dz-Bd7Ha] - Hitachi DZ-BD7HA Service Manual

Disassembly and Reassembly > Disassembly

(14) HDD Cover, HDD Block and HDF Circuit Board [For DZ-BD7HA]

Information:
The HDD cover and HDD block can be replaced without removing any other components:
Perform steps 1) – 8) below after opening the disc insertion block using the procedure shown in
"5-1 Items to Be Checked".
Note:
The HDD unit in a HDD block is a very delicate device, extremely susceptible to vibration or
impact: Handle it with care, referring to "1-4 Cautions when Handling 1.8-inch HDD (Hard Disk
Drive) for Hybrid/BD Camcorder".
1) Remove the screw [B].
2) Move the lock slider (a) in the direction of the arrow to open the disc insertion block.
3) Remove the screw [B].
4) Move the HDD cover (b) approx. 4 mm from the R case (c) in the direction of the arrow.
5) Insert a fi ne-tipped fl at-bladed screwdriver (d) into the hole in the R case, and release the tab of
HDD cover (g) in the direction of the arrow: Take care not to scratch the HDD cover or R case at
this time.
6) Remove the HDD cover in the direction of the arrow. Make sure at this time that neither the HDD
cushions (e) nor HDD block (f) is attached to the HDD cover. If they are attached to the HDD
cover, remove them before removing the HDD cover.
(a) Lock slider
(b) HDD cover
(c) R case
(d) Fine-tipped fl at-bladed screwdriver
(e) HDD cushion
(f) HDD block
(g) Tab of HDD cover
(h) HDF circuit board
(i) Plate spring
Fig. 5-3-14A
5 - 16