Evf Block, Jack Holder, Jack Cover S, Avj Circuit Board, Dcj Circuit Board, Jack Cover R, Battery Terminal, And Rear Cover - Hitachi DZ-MV230A Service Manual

4.8 EVF block, Jack holder, Jack cover S, AVJ circuit board, DCJ circuit board, Jack cover R,
Battery terminal, and Rear cover (Fig. 4-8)
Caution when disassembling:
Be careful not to damage the jack holder.
EVF block (A)
(1) Remove the two screws holding the EVF block.
Jack holder (B), Jack cover S (C), AVJ circuit board (D), DCJ circuit board (E)
(2) Remove the screw holding the jack holder.
(3) Open the jack cover S, and remove the jack holder in the direction of the arrow.
(4) Remove the jack cover S in the direction of the arrow.
(5) Widen the portion (a) of jack holder in the direction of the arrow.
(6) Remove the AVJ circuit board in the direction of the arrow.
(7) Remove the DCJ circuit board in the direction of the arrow.
Jack cover R (F)
(8) Release the two tabs one by one, and then remove the jack cover R.
Battery terminal (G), Rear cover (H)
(9) Release the two tabs, and then remove the battery terminal.
A : EVF block
B : JACK holder
C : Jack cover S
D : AVJ circuit board
E : DCJ circuit board
F : Jack cover R
G : Battery terminal
H : Rear cover
C
D
B
(6)
(2)
(a)
(7)
(5)
(3)
E
Fig. 4-8
F
H
(1)
(4)
(8)
G
(9)
A
(1)
2 - 15