Table of Contents
Advertisement
Troubleshooting > Display of Error Codes and Troubleshooting
4-3 Display of Error Codes and Troubleshooting
Restriction:
The information included in this section is exclusively for service personnel: Do not disclose it to
persons other than service engineers.
The camcorder is equipped with a self-diagnostic function: If the camcorder detects any problem, it
will choose an appropriate error code (4-digit alphanumeric) and store it in fl ash memory: Display
the error code to perform troubleshooting, according to the content.
4-3-1 Displaying error codes and clearing them
(1) Display method
1) Use the battery or AC adapter/charger to power the camcorder.
2) Set the Movie/Still switch to "Movie", and then turn the power switch to the "ON" position.
(The DZ-BD7HA can display error codes in both HDD and BD/DVD modes.)
Then operate the camcorder while watching the LCD monitor or viewfi nder.
3) Display the error code screen using the following button operation:
Simultaneously press the QUICK START, REC buttons and joystick
(2) Display clearing method
1) Press the STOP/EXIT button to restore the thumbnail screen.
4-3-2 Details of error code display
Up to four error codes of problems can be displayed
with the dates/times when the problems occurred.
If the same problem occurs repeatedly, it will be
judged as one problem, and the same error code will
not continue to appear.
If more than four problems occur, the error codes will
be erased beginning with the oldest problem, and the
code for the newest problem will be recorded.
If no error code is recorded, the line for error code
and problem occurrence date/time will be all zero (0).
Information:
To erase all error codes and reset to the default sta-
tus, perform system reset (remove the battery and
AC adapter/charger, and use a fi ne-tipped pen to hold
down the reset button for several seconds).
Fig. 4-3-1 Example of Error Code Display
4 - 12
.
Advertisement
Table of Contents
Troubleshooting
