Hitachi DZ-BD7HA Service Manual page 41

Troubleshooting > Messages and Troubleshooting
Message
HDD error has occurred.
HDD error has occurred.
Format the HDD now?
YES NO
HDD error has occurred.
Formatting is not complete.
HDD error has occurred.
Restart.
HDD has no image.
HDD has no Play List.
HDD includes protected
scenes.
Delete scenes?
YES NO
HDD is full.
Cannot add control info.
Insuffi cient free space avail-
able on disc. Delete unnec-
essary scenes.
Insuffi cient free space avail-
able on HDD. Delete unnec-
essary scenes.
Low temperature. Cannot
use BD. Turn off power, then
turn on again.
Cause/condition for
message to appear
Appears if a recorded fi le cannot be read
or written normally.
Appears when initializing the HDD was
interrupted previously.
Appears when formatting of HDD was
not completed normally, or it was inter-
rupted.
Appears if a problem occurs in HDD
during editing of video fi le.
Appears when playback or editing is
attempted using the Disc Navigation
function with no scene recorded on HDD.
Appears if switching of play list is se-
lected with no play list registered.
Appears if the HDD has a program
(scene) that was write-protected by a de-
vice other than the DZ-BD7HA/BD70A.
This occurs because the HDD protection
function equipped with DZ-BD7HA/
BD70A protects the entire HDD; it does
not handle protection of individual pro-
grams (scenes).
Appears if the number of scenes on play
list exceeds the upper limit while control
information is being added.
[Refer to *1 page 4-11]
Appears if a new playlist was created,
a playlist was edited, or a scene was
divided when the disc free space was
insuffi cient.
Appears if a new playlist was created,
a playlist was edited, or a scene was di-
vided when the free space on HDD was
insuffi cient.
Appears if the temperature of the BD or
the ambient temperature is lower than
the allowable operating temperature
(5ºC) of BD drive unit when the cam-
corder is turned on.
4 - 8
Troubleshooting
Initialize the HDD (all recorded data
will be deleted).
Choose "YES" when initializing
(deleting all recorded data), and then
execute.
Execute system reset (set the power
switch to "OFF", remove the power
supply, use a fi ne-tipped pen to hold
down the RESET button for a few
seconds), and then format the HDD
again.
Exit the Disc Navigation function, set
the power switch to "OFF", reconnect
the AC adapter/charger, and turn the
power switch to the "HDD" mode.
(The camcorder will automatically
repair the video fi le.)
Operate the camcorder after the mes-
sage disappears.
Operate the camcorder after the mes-
sage disappears.
Release the protection using the
device on which the programs (scenes)
were protected, or choose "YES", and
then delete the scenes.
Delete any unnecessary scenes, or
combine several scenes, and then
operate the camcorder.
Delete any unnecessary scenes, or re-
select scenes. Or replace the BD/DVD
with one giving suffi cient free space.
Delete any unnecessary scenes, or re-
select scenes. Or delete the scenes
for which editing is complete after
dubbing.
Turn the power switch to "OFF", and
then turn it to "ON" again.
If the message still appears even
after the above operation, turn the
power switch to "OFF", and then
move to a warmer place, making sure
there is no condensation.