Trouble Diagnosis Fl Owchart - Hitachi DZ-BD7HA Service Manual

Troubleshooting > Trouble Diagnosis
4-5-1 Trouble diagnosis fl owchart
Interpreting the trouble diagnosis fl owchart:
1) If removing any component is stated in the fl owchart, remove that component, referring to "5.
Disassembly and Reassembly".
2) If "Solder a lead wire to check point" is stated, solder a lead wire of approx. 10 cm according to
the list of check point: Be sure to remove the lead wire after trouble diagnosis is fi nished.
3) If "Set to service position (A) or (B)" is given in the fl owchart, set the camcorder to the
appropriate service position, referring to "4-5-2 Reassembly to enable service position".
4 - 21