Major Error Codes And Troubleshooting - Hitachi DZ-MV580EAU Service Manual

Troubleshooting > Self-Diagnosis Function and Troubleshooting

4-4-3 Major error codes and troubleshooting

Table 4-4-1 shows the error codes that are likely to frequently appear, and troubleshooting when
they appear.
If error codes other than those listed in Table 4-4-1 appear, check with the factory for
troubleshooting.
Error code Contents of problem
0400 Recognition of disc failed.
1100 Reading of data from disc failed.
10AE Disc physically damaged, i.g.,
10AF scratched or distorted.
0280 The optical pickup in disc drive unit
failed to move.
2881 Recognition of disc failed. [This
message is likely to appear frequently
when the ambient temperature is too
low (0°C or less)].
Table 4-4-1 Major Error Codes and Troubleshooting
4 - 22
Troubleshooting
1) Set the power switch to "POWER OFF", reattach the
battery or AC adapter/charger, and then set the power
switch to "VIDEO" or "PHOTO" (disc).
Take care not to subject the DVD video camera/
recorder to impact or vibrations at this time.
2) Set the power switch to "POWER OFF", remove the
disc and check whether or not it is dirty, scratched or
distorted. If it is dirty, clean it referring to the next
page, and then reload it. If it is scratched or distorted,
use another disc.
Then set the power switch to "VIDEO" or "PHOTO"
(disc).
3) Replace the disc without regard as to whether it is
dirty, scratched or distorted.
Replace the disc.
1) Check the ambient temperature.
2) Set the power switch to "POWER OFF", remove the
disc and check whether or not it is dirty, scratched or
distorted. If it is dirty, clean it, and then reload it. If it
is scratched or distorted, replace the disc.
Then set the power switch to "VIDEO" or "PHOTO"
(disc).
Disc cleaning method:
Use soft cloth to clean
from inner to outer
circumference in
axial direction.
[Never use solvent.]
3) Check to see whether or not condensation has
occurred. If condensation has occurred, set the power
switch to "POWER OFF" with the disc loaded, and
then leave the DVD video camera/recorder in a dry
place for 1-2 hours.
4) Replace the disc.