Enabling Universal Plug And Play (Upnp) - FLIR Voyager III Operator's Manual

Voyager III Webcam Interface
For Network Addressing, select Static.
2.
Enter the new value you want to use in the IP field. The Network Mask should
3.
fill in automatically (255.255.255.0).
Click Save to save your changes and exit the control page.
4.

Enabling Universal Plug and Play (UPnP)

If you need to frequently access the camera or JCU through the IP interface, you
can do this without having to type the IP address if your PC is configured to use
Universal Plug and Play (UPnP). In this case, the network devices display
automatically as icons and you can simply click on them to open the control page.
UPnP is typically not active on older computers using Windows XP but can be
activated by following the steps outlined here.
Note: The JCU and camera will display on the PC network only when the PC is
on the same network as the camera. If the PC is not configured with a static IP
address, the UPnP icons will not display.
UPnP Overview
UPnP is a set of networking protocols that allows devices on a network to connect
automatically, without the need for configuration by a network expert, thus
simplifying the implementation of networks and the installation of computer
components. A UPnP compatible device from any vendor can dynamically join a
network, obtain an IP address, announce its name, convey its capabilities upon
request, and learn about the presence and capabilities of other devices.
432-0005-00-10 Rev 100 — Voyager III Operator's Manual
75