Table of Contents
Advertisement
Voyager III Webcam Interface
Most PCs are configured to obtain an IP address automatically from the network.
You need to change the network settings for the PC to correspond to the
Voyager III camera. How you do this will vary depending on which operating
system your PC is using.
Find the Network Settings dialog using the steps appropriate for your operating
1.
system (Windows XP, Windows Vista, or Windows 7). The following image is
from Windows XP:
Click the selection for "Use the following IP address" and specify
2.
192.168.250.110 in the IP address field.
Make sure the subnet mask is set to 255.255.255.0 (this should fill
3.
automatically as you tab through the screen).
Click OK to save your changes and exit the Network Settings dialog.
4.
If the PC you are using is a laptop that you remove from the vessel and use on
other networks, make sure you reset the network settings to obtain an IP address
automatically to avoid IP conflicts.
Connect the PC to the Ship Ethernet Port
The Voyager III bulkhead box provides a single power over Ethernet (PoE) output
to be used by the JCU, labeled E2 Ship Ethernet. In a simple configuration, you
disconnect the JCU network cable from the bulkhead box and replace with your
PC network cable.
If you have a more complex LAN and have connected one or more additional
JCUs using an Ethernet switch (or equivalent) and PoE, you can connect the
computer to the switch instead. See the Voyager III Installation Guide for more
information about the physical configuration of the bulkhead box.
432-0005-00-10 Rev 100 — Voyager III Operator's Manual
65
Advertisement
Table of Contents
