Table of Contents
Advertisement
Voyager III System Startup
Assign JCU
Use the Assign JCU function to assign a JCU to a camera. When you select this
entry, v Select Camera. displays. The v indicates you can scroll down with the
puck to select a camera to control. When the ID of the camera you want to use
displays, push the puck in to select it. The camera ID will blink momentarily to
indicate it has been selected.
Normally only one camera is available, but you still must select it to complete the
association.
JCU Stndby?
When the JCU Stndby? option is selected, the display momentarily shows
Goodbye and then the backlit controls and the display are turned off. The JCU
buttons and puck will no longer control the camera. The Power/DIM button
remains backlit as long as power is supplied to the JCU. To power up the JCU
again, press and hold the Power/DIM button.
Camera Stndby?
When the Camera Stndby? option is selected, the camera will move to the
parked position and go into the standby state.
The JCU display will prompt the user to select a camera to control, in case you
want to switch to a different camera. If you select the same camera, it will return to
the powered on mode.
System Stndby?
When the System Stndby? option is selected, both the JCU and camera
associated with it are powered off.
Global Stndby?
When Global Stndby? is selected, all discovered cameras and JCUs found on
the network are powered down. This function is used to properly shut down all
cameras (return to park position) and JCUs prior to removing power with the
system breaker.
Global standby can also be achieved by pressing and holding the SCENE,
COLOR, and HOME buttons in unison.
Calibrate JCU
Calibrate JCU is used to standardize the movements of the JCU puck. This
function might be used, for example, if the camera responds at a different rate
when the puck is pushed left rather than right, or when the puck is twisted in one
direction compared to the other. The JCU display directs the user to move and
twist the puck in certain ways so the device can be calibrated.
After entering calibration mode, you will be instructed to move the puck to the
maximum extent possible in each direction separately. After that has been done,
pushing the puck in moves to the next step. For example, Rotate CW/CCW
27
432-0005-00-10 Rev 100 — Voyager III Operator's Manual
Advertisement
Table of Contents
