Table of Contents
Advertisement
Voyager III System Startup
Troubleshooting Tip: If the JCU does not have power, it may be connected to a
Power over Ethernet (PoE) switch that has not been powered on, or it may be
connected to a network switch that does not provide PoE power.
When the camera begins to power up, it goes through a pan/tilt sequence and
then moves to the home position. Starting, then Searching.. displays on
the JCU LCD screen. When the last-used camera is found, the message
changes to Connecting..., which continues to flash until the connection
process completes.
If this is the very first time the JCU has been used to connect to the camera, you
must first associate the JCU with the camera by selecting the camera. See
"Assign JCU" on page 27 for how to do this.
Troubleshooting Tip: if the JCU does not discover a camera, check to make
sure the JCU and the camera are both properly connected to the bulkhead box
either through a network or directly.
While the connection is being established, a series of screens displays as
various components are activated. How the screen looks will vary depending on
the particular configuration settings of your installation and if you have set a color
default other than the factory default supplied with the system.
In general, the following sequence occurs:
Two FLIR splash screens display. Initially the screen at the left appears. Then
1.
another splash screen with two important notices appears.
The screen then clears and after a few seconds a message displays:
2.
Loading, please wait
During bootup, a thermometer displays on the right of the screen until the
process completes. This is a feature of the thermal imager used to support
firefighter mode.
The screen clears and displays live video using default colors and icons.
3.
24
Product Not for use as a
Primary Navigation Tool
This IR Thermal Imaging System is an
Export Controlled item. Authorization by the
U.S. Government must be obtained prior to
any shipment outside the United States.
432-0005-00-10 Rev 100 — Voyager III Operator's Manual
Advertisement
Table of Contents
